FM Repeater SatCOM FMTP

SatCOM TP0 is a high-quality FM repeater for small satellites, designed by NanoAvionics’ partner LY3H.It is fully pre-programmed and configured prior to shipment according to customer request. No dedicated power-on signal is required, the device is either ON or OFF state and is ready for operation immediately after turn on.

Right after the repeater is activated voice/CW message is transmitted once. Later the message is being transmitted repeatedly every 4 minutes if uplink (CQ) signal is detected. Repeater can share single reception antenna with other receivers working on the similar band through passive, therefore highly reliable electronic splitter circuit.

Specifications
Type:
Flight Hardware
Modulation:
F3E (FM)
Output Power:
200 mW
Mass:
59 g
Frequency Band:
144 to 146 MHz (Rx)
Operating Temperature:
-30C to +80C
Connector:
PC/104
Frequency Band:
430 to 440 MHz (Tx)
Operating Voltage:
5V
Documents